• +86-371-68097667
  • service@stongboiler.com

Tag Archive Industrial oil fired boiler troubleshooting manufacturer

Industrial oil fired boiler troubleshooting

Industrial oil boilers are one of the most efficient for residential heating. The boiler basically consists of a burner and fuel tank. Once the burner has heated to the desired level, it transfers the heat into the boiler to heat the water. This produces steam which is then distributed throughout the house via a network of pipes, vents and radiators. Oil burners tend to be more efficient and reliable than the electric range. However, even oil fuelled boilers do develop problems from time to time. Below is a guide to help you troubleshoot.

Industrial oil fired boiler troubleshooting

Industrial oil fired boiler troubleshooting

Industrial oil fired boiler troubleshooting,first investigation boiler external fault condition. When the boiler furnace can not start, first check the external conditions are normal.such as:
1.the power supply is normal;
2.The water level is too high or too low;
3.if voltage is too low;
4.steam pressure (or temperature) is too high;
5.the coal supply pressure is normal;
6.the gas pressure is too high or too low;
7.the insurance is open circuit.
8. if the oil boiler is relatively old and that the thermocouple is the one that is not functioning well, it is best to replace it.
9.Power: Make sure the main power switch is in the “on” position.
10.Check Fuel Level: Check the oil storage tank to make sure it has fuel.
Next,General starting furnace is not normally due to external causes. When excluding external causes can not open oven reasons to reconsider the boiler itself the cause.
Finally, investigation boiler itself, Check from the failure of the beginning program until to the program controller.